How to Clean the SmartShirt?
How to Clean the SmartShirt?
Written by Judit Vigh
Updated over a week ago
Always refer to the cleaning instructions when the SmartShirt need washing.
- Disconnect Processing Unit from Shirt.
- Open the back zipper all the way for easier access.
- Turn the Shirt inside out.
- Open the bottom zipper all the way.
- Remove the electronics on the side.
- Open chest zipper on the side all the way up. Remove cable as you go.
- Open shoulder zipper on the same side all the way up.
- Carefully nudge pulse electronics out of the collar. Do NOT pull it out by the wire.
- Continue with removing shoulder touch sensing electronics.
- Open arm zipper all the way down.
- Carefully nudge pulse electronics out of the cuff. Do NOT pull it by the wire.
- Repeat on the other side in the same order.
- Remove complete wire harness with a total of six touch sensing electronic circuits.
- Place Shirt in laundry mesh wash bag.
- Wash Shirt in cold water, do not iron it.
- Replace electronics only when shirt is completely dry.
- Place on of the pulse electronics with a single attache cable in the cuff. Carefully nudge it into position within the cuff.
- Place cable from cuff under arm zipper and close the zipper all the way up.
- Place one of the pulse electronics with a single attached cable in the cuff. Carefully nudge it into position within the cuff.
- Place pulse electronics in collar. Pléace both cables going to this pulse electronics under shoulder zipper. Close shoulder zipper.
- Continue with placing the cable under the chest zipper. Close zipper all the way down.
- Repeat reinstalling electronics on the other side, starting at the cuff, continuing at the shoulder and the collar.
- Place cable under bottom zipper and close the zipper.
- Turn the Shirt back outside. Close back the zipper.
- Put on the Shirt and the belt pouch with the Processing Unit.
- Connect the electronics of the Shirt to the Processing Unit and you are good to go!